How to use and clean silicone gym grip pads
GeckoPad goes between your palm and the handle, one pad per hand. There is no left or right pad to sort out and no strap to tighten. The first check is whether the silicone lies flat when your hand closes.

Set up on an unloaded handle
- Start with dry hands, dry pads and a clean handle. Place each pad over the part of your palm that will meet the bar.
- Close your hand around the handle. Your thumb and fingers should close comfortably and the pad should sit in a single layer.
- Open your hand and check the edges. If one edge creased under your fingers, move the pad slightly and try again before lifting.
If a pad shifts during a set
Support or rack the weight before adjusting the pad. Check for moisture, a folded edge or a handle too wide for the thickness you chose. If you cannot get a steady hold during a light test, leave the pad off that handle.
Wash, dry and pack
After training, wash both faces with mild soap and water. Rinse away the soap and leave the pads out until both sides are dry. Turn them over if the underside is still damp, then return the pair to your gym bag. Before the next session, look for tears or worn edges that keep a pad from sitting flat.
If the pad lies flat but the handle still feels too large, the 2.5 mm and 5 mm comparison explains what changes when you switch thickness.